ToneCarve · how it works

Three steps from your mix to the car—and back.

Replace the drive-around guessing game with an exact source-to-capture comparison and a repeatable translation workflow inside the DAW.

Step 01 · The source

Start with the exact mix you are trying to finish.

Export or select the current WAV and label its mix version. ToneCarve fingerprints that source so every road test remains connected to the correct bounce instead of a generic reference tone.

Exact source WAV and mix version
Representative section or full eligible file
No unrelated calibration signal required

Step 02 · The capture

Play and record that same mix in the vehicle.

The single-device research flow keeps playback and microphone capture inside one foreground session. Repeat takes and documented settings help expose interruptions before bad audio is accepted.

One source file and one vehicle session
Actual recorded duration and byte checks
Repeat takes under matching conditions

Step 03 · The comparison

Inspect what changed in this song, then return to the DAW.

ToneCarve aligns the source and vehicle capture, then looks for track-specific changes in balance, impact, clarity, dynamics, and width. Suggestions remain adjustable and should improve translation—not invert one car’s speakers.

Source and capture on matching timelines
Section-specific translation flags
Save recommendations with the correct mix version

Your mix. Your road test.

See what a track-specific comparison looks like.

Open comparison demos →